Exit demo 640-692 CCT Routing and Switching PDF format · free preview

Cisco 640-692 - Questions & Answers

Free preview · every answer includes a full explanation

Product page: https://prepkeys.com/640-692.html

Question 1
Multiple choice

Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)

A.

RAM

B.

NVRAM

C.

flash memory

D.

HTTP server

E.

TFTP server

F.

Telnet server

Question 2
Multiple choice

On which three operating systems does HyperTerminal not come pre-installed? (Choose three)

A.

Windows XP

B.

Windows Vista

C.

Mac OSX

D.

Windows 98

E.

Windows 7

F.

Windows 2000

Question 3
Multiple choice

Which three of the following describe Fast Ethernet? (Choose three)

A.

1QBASE-T H B

B.

100BASE-T

C.

10-Mb/s speed

D.

100-Mb/s speed

E.

requires Category 3 or higher UTP cabling

F.

requires Category 5 or higher UTP cabling

Question 4
Multiple choice

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0.
Based on the output from RouterA, what are two possible reasons for the failure? (Choose two.)

A.

The cable that is connected to S0/0 on RouterA is faulty.

B.

Interface S0/0 on RouterB is administratively down.

C.

Interface S0/0 on RouterA is configured with an incorrect subnet mask.

D.

The IP address that is configured on S0/0 of RouterB is not in the correct subnet.

E.

Interface S0/0 on RouterA is not receiving a clock signal from the CSU/DSU.

F.

The encapsulation that is configured on S0/0 of RouterB does not match the encapsulation that is configured on S0/0 of RouterA.

Question 5
Single choice

Which port displays the bootup process on a Cisco device?

A.

ATM

B.

BVI

C.

Console

D.

Ethernet

Question 6
Single choice

Which statement describes the effect of the copy run start command on a router in enable mode?

A.

The running configuration of the router is saved to NVRAM and used during the boot process.

B.

The router reboots and loads the last saved running configuration.

C.

A copy of the running configuration of the router is sent by FTP to a designated server.

D.

A new running configuration is loaded from flash memory to the router.

Question 7
Multiple choice

Which three pieces of information about a device can be seen from the show version command? (Choose three)

A.

CPU load

B.

Device model

C.

Installed DRAM

D.

Installed flash

E.

Locally configured IP addresses

Question 8
Single choice

Which address facilitates the routing of packets over an IP network?

A.

MAC

B.

transport

C.

network

D.

physical

Question 9
Single choice

Which command initiates the copy of an IOS image to a Cisco device?

A.

copy flash tftp

B.

copy tftp flash

C.

copy tftp ftp

D.

copy tftp nvram

E.

xmodem flash

Question 10
Single choice

Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?

A.

transport type all

B.

transport output all

C.

transport preferred all

D.

transport input all

Showing 10 of 92 questions · Unlock the full set