HP HPE0-V14 - Questions & Answers
Free preview · every answer includes a full explanation
Product page: https://prepkeys.com/hpe0-v14.html
Which HPE solution brings together CPU, Memory, and Disk with an unpredictable workload into a single management infrastructure?
Read the question, and then refer to the exhibit.
<Switch-A>display interface Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state:
Administratively DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address:
d894-03fb-793d Description: Ten- GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK_SFP_PLUS Unknown-speed mode, unknown-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100%
Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk
VLAN Passing: 10, 20 VLAN permitted: 10, 20 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last
link flapping: 0 hours 0 minutes 18 seconds Last clearing of counters: Never Peak input rate: 78 bytes/sec, at 2011-03-31 04:55:57 Peak output rate: 15 bytes/sec, at 2011-03-30 23:00:57 Last 300 second input: 0
packets/sec 67 bytes/sec -% Last 300 second output: 0 packets/sec 14 bytes/sec -% Input (total): 62670
packets, 8565340 bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input (normal): 62670
packets, -bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0
giants, 0 throttles 0 CRC, 0 frame, -overruns, 0 aborts ?ignored, -parity errors Output (total): 3707 packets,
1294835 bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output (normal): 3707 packets, -bytes
0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output: 0 output errors, -underruns, -buffer failures 0
aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, -no carrier
A customer added a new switch to their network. They connected it using interface Ten-GigabitEthernet 1/0/1. They are using VLAN 10 and 20 for the devices in their network.
The new switch was fully operational. Then, the customer experienced a power failure later that day and could not reach any device on the new switch after the power returned.
From the output in the exhibit, would could be the issue?
A customer needs to deploy an application on a newly-installed HPE ProLiant server, but they report that
the server is not online. They call you for remote support. The IP address on the production network cannot be reached. You are evaluating the probable root causes of this issue.
According to the troubleshooting methodology, what are next two steps? (Select two)
A customer needs a server memory subsystem that meets the following requirements:
1. approaches the speed of traditional DRAM
2. ensures high capacity, high performance, and ongoing data safety in case of a power failure
Which HPE memory feature meets the customer needs?
A customer needs to integrate a new digital video surveillance solution into their existing environment and available network ports. The solution needs to include redundant hypervisor servers and a redundant SAN with a shared Fibre Channel attached storage array.
You plan to propose the following configuration:
2 HPE DL380 Gen10 servers with dual processors, 384 GB of memory, dual port 10 Gb NIC, and High Performance Fan Kit 1 HPE MSA 2050 Dual Controller Storage Array with 24x 1.8 TB 10 K SAS drives and 96x 7.2K NL drives
4 VMware vSphere Standard licenses
1 VMware vCenter Server Foundation licenses
5 year 24x7x4 support for all equipment
What must be added to the configuration to provide a complete solution? (Choose two.)
Which protocol should be used to access an exported directory on a network-attached storage device?
Refer to the exhibit.
You are asked to review a server configuration for a customer before it is quoted. The server will be used in a business-critical environment and high availability is required. The server configuration is shown in the exhibit.
What should be added to the configuration to ensure availability?
Which HPE feature enables the customer to achieve this A customer has a new virtual environment. They selected HPE servers for the environment in order to achieve better performance for their applications.
server performance improvement?
Which feature in a block storage array eliminates redundant data through the process of using indexes that refer to the original set of data?
Why is SNMPv2c considered to be insecure?