Exit demo NCM-MCI Nutanix Certified Master - Multicloud Infrastructure PDF format · free preview

Nutanix NCM-MCI - Questions & Answers

Free preview · every answer includes a full explanation

Product page: https://prepkeys.com/ncm-mci.html

Question 1
Multiple choice

An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS. The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.

What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy? (Choose two.)

A.

The VM is missing the required snapshot needed to implement the QoS Policy.

B.

The VM was not created as an AFS virtual machine.

C.

The SQL Server VM has volume groups attached.

D.

It was cloned from another SQL Server VM that was a member of the QoS Policy.

Question 2
Single choice

An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to the CVM in question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.

The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

A.

Replace the cable from eth2 to the switch

B.

Remove eth3 from br0-up and monitor for new alerts

C.

Check the port on the switch side for any errors

D.

Enable balance-s1b on br0-up and monitor if a problem persists

Question 3
Single choice

Refer to the exhibit.

A Nutanix host is connected as shown in the exhibit with br0-up set to active/backup. Physical Switch 1 experiences a power outage causing br0-up to failover to using eth2. The CVM and host become inaccessible. User VMs restart on other hosts in the cluster, which causes a disruption to those VMs.

Which configuration issue likely caused this outage?

A.

Bridge br0-up should be configured to use balance-tcp rather than active/backup.

B.

The CVM should have eth1 connected to the OVS.

C.

The upstream port for eth2 is missing a VLAN.

D.

The user VMs only have one NIC

Question 4
Single choice

An administrator receives a notification that storage in a Nutanix cluster is unavailable. The cluster consists of five nodes and is configured with a Fault-Tolerance level of 1 (FT-1).

Upon investigation, the administrator finds the following:

1. All AHV hosts are powered on and the CVMs are running
2. Nodes A, B, and C are connected to one top of rack switch
3. Nodes D and E are connected to a second top of rack switch
4. The cluster status command run on Node A shows that CVM services on nodes D and E are down

Which issue is causing the storage outage?

A.

The default gateway for the CVMs and AHV hosts is down.

B.

The switch connecting Nodes D and E is down.

C.

The genesis process is down on both Nodes D and E.

D.

Nodes D and E are in maintenance mode.

Question 5
Multiple choice

An administrator protected a DB VM running on a Nutanix cluster with NearSync Replication, which schedules to repeat every 15 minutes to a second site. The daily change rate is low. During nightly backups, the replication window is missed due to write volume.

Which two options describe the expected behavior? (Choose two.)

A.

NearSync stops working and fails over to the remote site.

B.

Protection Domain transitions back to the hourly schedule.

C.

The Administrator needs to re-enable it manually.

D.

The system continuously tries to get to the NearSync schedule.

Question 6
Single choice

An administrator is performing a set of routine checks and notes that Prism Central is running with 4 vCPUs and 21 GB RAM. The organizations environment is based on two Nutanix clusters with 170 VMs plus a Legacy vSphere infrastructure. No manual changes have been done on Prism Central VM.

Which configuration justifies the current Prism Central configuration?

A.

Nutanix Move is running on Prism Central to import VMs from the Legacy Cluster.

B.

Prism Central was installed for Large Deployment environments.

C.

Prism Central is running on the legacy duster and requires more RAM.

D.

Nutanix Leap and Nutanix Flow have been enabled on Prism Central

Question 7
Multiple choice

An administrator needs to relocate an AHV cluster to a new datacenter during a maintenance window. The cluster will use the same IPs in the new datacenter.

Which two steps should be taken to prepare for this task? (Choose two.)

A.

Stop all Nutanix Files clusters

B.

Relocate the linked LDAP servers

C.

Shut down all user VMs in the cluster

D.

Reconfigure IPMI for the new datacenter

Question 8
Single choice

An administrator has a VM that consumes large amounts of storage and has the following characteristics:

1. Create large / sequential writes
2. Data must be kept for years
3. Data is normally only accessed at the end of the year to run report The administrator decides to use
Erasure Coding to save space.

Which feature should the administrator utilize to save space for this VM?

A.

Inline Compression

B.

Flash Mode

C.

Cache Dedup

D.

Post-Process Compression

Question 9
Single choice

An administrator finds that home shares cannot be configured in a new Files 3.5 deployment.

Why is this happening?

A.

NFS default access is set to Read Only.

B.

Multi-protocol access is not configured.

C.

Access Based Enumeration is not enabled.

D.

The system is deployed as a single FSVM.

Question 10
Single choice

An administrator needs to migrate workloads from a Nutanix cluster running VMware ESXi to Nutanix AHV.
The migration process needs to be completed in multiple VM groups and support roll back in case any problems are found during user acceptance testing.

Which action should the administrator perform?

A.

Use Cross Hypervisor DR to replicate VMs from ESXi to AHV

B.

Use VMware Converter

C.

Use Nutanix one-click cluster conversion from ESXi to AHV

D.

Use storage live migration

Showing 10 of 106 questions · Unlock the full set