Exit demo NSE7_SDW-6.4 Fortinet NSE 7 - SD-WAN 6.4 PDF format · free preview

In this set

Single choice 38

Multiple choice 42

Free demo preview

10 sample questions

Full product includes 80 questions.

Purchase the full set to unlock every question in your account.

PDF & Online Q&As

PDF + online access Study in your browser or print a clean PDF copy.

Answer key included Check your choices while you study.

Reviewed content Question sets are maintained for exam prep use.

15 years online A long-standing team focused on exam Q&A products.

Fortinet NSE7_SDW-6.4 - Questions & Answers

Free preview · every answer includes a full explanation

Product page: https://prepkeys.com/nse7-sdw-64.html

Question 1

Multiple choice

Which three parameters are available to configure SD-WAN rules? (Choose three.)

Application signatures

Type of physical link connection

URL categories

Source and destination IP address

Internet service database (ISDB) address object

Question 2

Single choice

Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. 0/0).

Question 3

Multiple choice

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

Specify incoming interfaces in SD-WAN rules.

Question 4

Multiple choice

Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)

Member metrics are measured only if an SLA target is configured.

SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy.

When configuring an SD-WAN rule, you can select multiple SLA targets of the same performance SLA.

SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements.

Question 5

Single choice

Refer to the exhibit.

Which statement about the command route-tag in the SD-WAN rule is true?

It enables the SD-WAN rule to load balance and assign traffic with a route tag

It tags each route and references the tag in the routing table.

It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

It ensures route tags match the SD-WAN rule based on the rule order

Question 6

Multiple choice

Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.

Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

Question 7

Single choice

Refer to exhibits.

Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.

Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

Question 8

Multiple choice

Refer to exhibits.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect
how FortiGate processed traffic.

Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

The implicit rule overrides all other rules because parameters widely cover sources and destinations.

SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.

The initial session of an application goes through a learning phase in order to apply the correct rule.

Question 9

Single choice

Refer to exhibits.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.

Based on the exhibits, which statement is correct?

Both SD-WAN member interfaces have used separate SLA targets.

The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Port1 became dead 1ecause no traffic was offload through the egress of port1.

SD-WAN member interfaces are affected by the SLA state of the inactive interface

Question 10

Single choice

Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys sdwan log

diagnose sys sdwan health-check

diagnose sys sdwan intf-sla-log

diagnose sys sdwan sla-log

Showing 10 of 80 questions · Unlock the full set